Vari Lite VL3000 Series User Manual - page 24
VARI
❋
LITE® - VL3000™ S
ERIES
L
UMINAIRE
U
SER
’
S
M
ANUAL
6
20 - Au g- 03
0 2 . 9 6 7 8 . 0 0 0 1 A
Luminaire Overview
The following illustration shows the external luminaire components and controls.
Figure 1-2: VL3000 External Components and Controls
DATA THRU
ENTER
MENU
AC PWR
DATA IN
~
AC IN
Main Power
Switch
AC Input Cable
Data In
Data Thru
Product Label ID
AC Input Cable
Head Assembly
Input Panel
Menu Display
Provides DMX In and Thru,
and AC Power connections.
Used to input manual
commands, program, test,
set defaults and access
Houses Master Control
Houses color, gobo, strobe, zoom lens
and/or beam spreader mechanisms
Yoke Assembly
Backcap Assembly
Provides access to lamp
for replacement and
provides controls for
internal status information.
beam adjustment.
(see detail below)
Upper Enclosure Assembly
Houses power supply, ballast,
and display board.
Truss Hook Bracket
Attaches to enclosure base
to allow truss hook installation.
CAUTION:
RISK OF EXPOSURE TO EXCESSIVE ULTRAVIOLET RADIATION. DO NOT OPERATE
WITHOUT COMPLETE LAMP ENCLOSURE IN PLACE OR WHEN LENS IS DAMAGED.
ATTENTION:
RISQUE D'INCENDIE. UTILISER UNIQUEMENT UNE LAMPA HALOGENE EN METAL DE
TYPE H, 1200 WATT, 100V ET UN SUPPORT SFc10-4.
CAUTION:
RISK OF FIRE. USE ONLY 1200 WATT, H TYPE 100V METAL HALIDE LAMP,
SFc10-4 BASE.
DISCONNECT FIXTURE
BEFORE RELAMPING
CAUTION: HOT LAMP
DO NOT
OPEN FOR 5 MINUTES
AFTER SWITCHING OFF.
X
Y
Z
Beam Adjustment Controls
Input Panel Components
Board (MCB).
(dependant on luminaire model).