Vari Lite VL3000 Series User Manual - page 74
VARI
❋
LITE® - VL3000™ S
ERIES
L
UMINAIRE
U
SER
’
S
M
ANUAL
5 6
20 - Au g- 03
0 2 . 9 6 7 8 . 0 0 0 1 A
Routine Maintenance
Lamp Replacement
WARNING: Ensure that power is removed from luminaire when installing lamp.
CAUTION: Wear cotton gloves or other covering while installing lamp. Touching lamp glass with
bare fingers will leave oil and may cause the lamp to explode or reduce lamp life. If touched, use
alcohol and cotton cloth to thoroughly clean glass portion of lamp.
To replace lamp:
Step
1. Ensure power is removed from luminaire.
Step
2. At rear of luminaire head, loosen four 1/4-turn screws and slide lamp box back and out (it is
hinged).
Step
3. One side at a time, press lamp lock lever forward and remove current lamp.
Step
4. Position new lamp with dimple side down. One side at a time, press lamp lock lever forward
and insert lamp connector. Ensure lamp is seated fully in place.
Step
5. Close lamp box and re-tighten 1/4-turn screws.
Step
6. Align lamp as detailed in
“Align Lamp” on page 57
.
Figure A-1: Installing Lamp
Lamp (dimple side down)
Reflector
Lock Lever
Lamp Box
* Luminaire Head Not Shown For Clarity
Lamp Connector
CAUTION:
Do not touch lamp or
reflector with bare fingers.
CAUTION:
Allow lamp to cool
before servicing.