Vari Lite VL3000 Series User Manual - page 34

VARI

❋

LITE® - VL3000™ S

ERIES

 L

UMINAIRE

 U

SER

’

S

 M

ANUAL

1 6

20 - Au g- 03

0 2 . 9 6 7 8 . 0 0 0 1   A

Addressing

Program Starting Address

The address setting for DMX console controlled systems is entered using the Menu Display (refer to 

“Menu Operation” on page 42

). The luminaire retains the DMX address even if power is removed.

Note:  Refer to your console operating instructions for specific information regarding its addressing 

requirements.

Program a DMX starting address:

Step

1. Press [Menu].

Step

2. Press [Up] / [Down] arrows until Address appears. Press [Enter].

Step

3. Press [Up] / [Down] arrows to enter starting address.

Step

4. Press [Enter] to set.

Program Starting Address Without Calibrating 

Luminaire

It is possible to bypass the calibration sequence and go directly to the Menu Display programming in 

order to pre-program an address setting.

Program starting address without calibrating luminaire:

•

While powering up luminaire, press and hold [Menu]. Program address as in 

Program Starting 

Address

 above.

Note:  The luminaire will require a reset to restore control.