Vari Lite VL3000 Series User Manual - page 68
VARI
❋
LITE® - VL3000™ S
ERIES
L
UMINAIRE
U
SER
’
S
M
ANUAL
5 0
20 - Au g- 03
0 2 . 9 6 7 8 . 0 0 0 1 A
Self-Tests
Running Parameter Tests
The luminaire is capable of running self-tests by using the Testmenu functions.
When running tests on multiple luminaires, a male termination connector is required at the last
luminaire in the link. Refer to
“Connecting Data and Power” on page 14
for more information
regarding the construction of this connector.
Note: After 10 seconds of inactivity, the menu display will change to the default state showing the
address.
To connect luminaires for simultaneous testing:
Step
1. At last luminaire, install male termination connector into DATA THRU XLR connector.
Step
2. At master luminaire Menu Display, press [Menu].
Figure 4-2: Testing Setup
To run tests:
Step
1. Press [Menu].
Step
2. Press [Up] / [Down] arrows until Test appears. Press [Enter].
Step
3. Use [Up] / [Down] arrows to select a parameter to test. Refer to
“Menu System Function
Chart” on page 45
for a complete list of test parameters which can be chosen.
Step
4. Press [Enter] to run test.
Step
5. Press [Menu] to stop test at any time.
DATA THRU
ENTER
MENU
AC PWR
DATA IN
~
AC IN
DATA THRU
ENTER
MENU
AC PWR
DATA IN
~
AC IN
DATA THRU
ENTER
MENU
AC PWR
DATA IN
~
AC IN
Termination Connector
Master Luminaire
Luminaire 1
Luminaire 2
Data Thru
Data Thru