Vari Lite VL3000 Series User Manual - page 61
M
ENU
S
YSTEM
: M
ENU
O
PERATION
4
0 2 . 9 6 7 8 . 0 0 0 1 A
20 - Au g- 03
43
To enter the menu system, first press [Menu]. The functions displayed will be 1st level functions.
Scroll through the 1st level functions by pressing [Up] / [Down] arrows. Once the desired function
appears in the display, press [Enter]. You are now at the 2nd level. Once again, press the [Up] /
[Down] arrows to scroll through 2nd level functions. Press [Enter] to access 3rd level functions and so
forth. When the highest level for the function is reached, [Up] / [Down] arrows can be pressed to enter
a value or select a toggle activation such as On/Off. Press [Enter] to store the value or select an action.
For example:
Default State
The menu display’s default state during normal operation is to display the DMX address. After 10
seconds of inactivity at the display, it will change to the default state.
After longer periods of inactivity, the menu display will switch to its off state. The default state for this
feature is 5 minutes, however, different time lengths can also be programmed.
To program a different time length for menu off feature:
Step
1. Press [Menu].
Step
2. Press [Up] / [Down] arrows until Config (Configuration) appears. Press [Enter].
Step
3. Press [Up] / [Down] arrows to access Display. Press [Enter].
Step
4. Press [Up] / [Down] arrows to select either 30 Sec (30 seconds), 5 Min (5 minutes), 10
Min (10 minutes), or ON (on indefinitely). Press [Enter] to set.
Shortcuts
A few button combinations are provided as shortcuts for frequently used menu functions. These
shortcuts are as follows:
•
Pressing [Enter] and [Up] at the same time = Lamp On
•
Pressing [Enter] and [Down] at the same time = Lamp Off
•
Pressing [Menu] and [Up] at the same time = Recalibrate
•
Pressing [Menu] at Power up interrupts calibration. See
“Program Starting Address Without
Calibrating Luminaire” on page 16
for more information.
1st Level
Test
All @1
RUN TEST
2nd Level
3rd Level