Wacker Neuson RCP 20 Operator's Manual - Operation
Manual is about: Cutting machine with interchangeable head
of
62
24
Operation
RCP
7.2
Adjusting the machine
Adjusting the stop screw
1. Set the pressure release lever in the Release/Idle position.
2. Open the protective hood (only installed on some machine designs).
3. Loosen jam nut.
4. Place the workpiece on the fixed knife.
5. Set the stop screw so that the workpiece is perpendicular to the axis of the
machine.
6. Tighten the jam nut.
WARNING
Starting the machine.
Danger of injuries from uncontrolled starting of the machine.
f Remove the plug from the plug receptacle before all work on the machine.
Item
Designation
1
Movable knife
2
Jam nut
3
Stop screw
4
Fixed knife
5
Workpiece
Protective hood (without illustra-
tion)