Wacker Neuson RCP 20 Operator's Manual - Operation
Manual is about: Cutting machine with interchangeable head
of
62
26
Operation
RCP
7.3
Starting up
Connecting the machine to the power supply
1. If required, connect the machine to a permitted extension cable.
Note: See chapter Technical data for the permitted lengths and cross-section
areas of extension cables.
2. Insert the plug into the plug receptacle.
NOTICE
Worn out knives.
Premature wear of the machine.
f Before beginning work check the sharpness of the knife visually.
f Change worn out knives.
NOTICE
Electrical voltage.
Incorrect voltage can cause damage on the machine.
f Check if the voltage of the current source corresponds with the information
of the machine, see chapter Technical Data.
CAUTION
Electrical voltage.
Danger due to short circuit.
f Check power cable for signs of damage.