WAGNER Cordless Lawn Sprayer Owner's Manual - Caution
Flat Tip
The flat tip produces a medium flow of
material in a long, narrow spray pattern. The
pattern can be positioned vertically or
horizontally by turning the spray tip. This tip
may be useful for groups or rows of plants
and lawns or other large surfaces.
Shower Spray Tip
The shower spray tip produces a heavy flow
of material over a wide area. This tip may be
useful for saturating the ground around a
group of plants.
The root feeder assembly allows you to deliver chemicals or water to
the roots of plants and trees.
1. Slide the square hole of the
cross bar onto the small end
of the ground tube.
2. Turn the cross bar until the
square hole fits down onto
the flats of the ground tube.
3. Slide the locking clip onto the
groove above the cross bar.
Garden Hose
1. Slide the plain end of the
garden hose adapter
hose all the way onto the
small end of the ground
tube.
2. Squeeze the tabs of the
locking collar, slide it
over the small end of the
ground tube, and release
the tabs.
3. Hand-tighten the garden
hose fitting onto the
garden hose.
4. Turn on the garden hose.
5. Push the tip of the root feeder into the ground. The water
running from the garden hose through the ground tube will
make it easier to push the root feeder into the ground.
6. Allow the garden hose to continue to run or turn off the hose
and attach the lawn sprayer to the root feeder.
Lawn Sprayer
Use the garden hose to help insert the root feeder before attaching
the lawn sprayer.
1. Slide the plain end of the lawn sprayer adapter hose all the way
onto the small end of the ground tube.
2. Squeeze the tabs of the locking collar, slide it over the small
end of the ground tube, and release the tabs.
3. Hand-tighten the locking collar of the spray wand adapter tube
directly onto the spray handle (no spray tubes).
4. Turn on the lawn sprayer.
A thorough cleaning after each use of the cordless lawn sprayer is
important to keep it in good working order.
Do not turn the sprayer upside down or on its side. If liquid
gets inside the drive housing it could damage the sprayer.
The following steps outline the basic cleanup procedures. For more
detailed instructions on how to perform each step, refer to the
Detailed Cleanup section in this manual.
1. Empty the sprayer.
2. Flush the sprayer.
3. Remove the pump assembly.
4. Remove the inlet valve.
5. Remove the outlet valve
6. Clean the pump assembly.
and relief valve.
7. Clean and lubricate the
8. Reassemble the pump and
piston and O-ring.
attach it to the drive housing.
NOTE:
Perform the pressure relief procedure before cleaning
the lawn sprayer.
CAUTION
NOTE:
When using insecticides, herbicides, or pesticides,
store or dispose of them according to the
manufacturer’s instructions.
NOTE:
Check the level of fluid in the lawn sprayer tank after
several minutes of operation. If the level has not gone
down, it is likely that the holes at the bottom of the
ground tube are plugged. Stop the lawn sprayer and
disconnect it from the root feeder. Attach the garden
hose to the root feeder and turn it on briefly to clear
the holes.
Ground Tube
Locking Collar
Hose
Cross Bar
Ground Tube
Locking Clip
NOTE:
When using the root feeder assembly to deliver any
type of chemicals, carefully follow the
manufacturer’s instructions.
R
©1997 Wagner Spray Tech. All rights reserved.
5
English