WaterRower M1 SERIES Owner's Manual - page 7
12
13
sTep 1
Lay the rails on the floor and connect the rear spacer using 4 (2 on either side)
of the male button head screws and the Allen key provided.
Button Head screw x 4
5mm Allen Key
x2
x2
Note: The black extrusions are positioned on the inside.
Rear spacer
sTep 2
Place the seat assembly between the rails with the indent facing towards the
rear spacer. The larger vertically mounted wheels (the load wheels) should sit
on the plastic extrusions on the top of the rail. The smaller horizontal wheels
below the seat (the guide wheels) should sit between the rails. It may be
necessary to separate the rails slightly to allow the guide wheels to fit down
between the rails.
sTep 3
Place the tank assembly between the rails.
sTep 4
secure the tank assembly to the rails using 4 (2 on either side) of the button
head screws. The bolts go through from the inside of the forward riser bracket
into rivets in the rail. (Diagram B).
B
sTep 5
Use the included syphon pump (or a hose if available) to fill the tank to the
desired level with municipal water.
Do not overfill your WaterRower. Anything beyond Level 19 (the maximum
level) may risk leaking and void the warranty.
1) To pump water, turn the knob clockwise to close valve as shown in figure A
2) Locate water source above (higher than) water destination:
-see Figure B for filling tank
-see Figure C for emptying tank
3) squeeze pump 4-5 times until water flows
4) Turn knob counter-clockwise to allow air into the pump and end the syphon.
Button Head screw x 4
A)
B)
C)