WaterRower S4 series Owner's Manual - page 7
12
13
STEP 1
Lay the rails on the floor and connect the rear spacer using the female JCN nuts and the Allen
keys provided.
STEP 2
Place the seat assembly between the rails with the indent facing towards the rear spacer.
The larger vertically mounted wheels (the load wheels) should sit on the plastic extrusions on
the top of the rail. The smaller horizontal wheels below the seat (the guide wheels) should sit
between the rails. It may be necessary to separate the rails slightly to allow the guide wheels
to fit down between the rails.
Rear Spacer
The black extrusions are
facing the inside of the rails.
JCN Nut (x4)
Allen Keys
STEP 3
Place the tank assembly between the rails.
Insert the JCN Nuts and JCB Bolts attaching the tank to the rails at locations A & B. The nuts
should be placed on the inside and the bolts on the outside.
STEP 4
JCN Nut
(x4)
JCB Bolt
(x4)
A
B
Allen Keys
STEP 5
Place the footboard between the rails positioning the top two holes over the two threaded
holes in the tank unit. It may be necessary to slightly loosen the two bolts on the Top Deck (B)
to allow the footboard clearance. Insert the JCN Nuts and JCB Bolts attaching the Footboard
to the Rails at A. Screw the Handle Rests into position using the Handle Rest Bolts (C); do not
over tighten.
*Should you experience any problem with aligning the components, loosen all the fasteners,
align and re-tighten.
Top Deck Bolts
Handle Rest Bolt
(x2)
Handle Rest
(x2)
JCN Nut
(x4)
JCB Bolt
(x4)
B
C
A
Allen Keys