WaterRower S4 series Owner's Manual - page 9
16
17
1) To pump water, turn the knob clockwise to close valve as shown in figure A
2) Locate water source above (higher than) water destination:
▪
See Figure B for filling tank
▪
See Figure C for emptying tank
3) Squeeze pump 4-5 times until water flows
4) Turn knob counter-clockwise to allow air into the pump and end syphon.
HOW TO FILL AND EMPTY THE TANK
A
B
C
WATER LEVEL
The Level Gauge is positioned on the side of the tank. Information on the sticker includes
WaterRower contact information and the Water Level Gauge. The maximum level to fill the
tank is Level 19. DO NOT fill above the maximum level - this could void the warranty. The
standard Calibration Level is Level 17.
TROUBLESHOOTING
1. Monitor flashing zeros
Solution 1: Try raising the sensor disk (located on top of the clutch).
During shipment, the disk may have shifted.
Solution 2: Loosen and retighten the bolts on the upper deck and forward riser.
If these bolts are not uniformly tightened during assembly, the alignment may be off.
2. Loosening bolts -
over time and with use bolts can come loose. Use the 5mm Allen
key to gently tighten the bolts. If the bolts continue to loosen use a small amount of
medium strength Loctite
®
to fasten the nuts and bolts more securely.
3. Monitor not turning on -
check the batteries positioned behind the monitor.
Unscrew the monitor and gently lift to access the battery pack.
4. Monitor not counting down -
check that the monitor and sensor connector are
connected. Check all wiring is intact.
5. Paddle not turning smoothly -
Loosen all tank bolts and retighten. See
instructions at:
http://www.waterrowerservice.com/pdfs/troubleshooting_all_rubbing_tank.pdf
For other troubleshooting and service tips, please visit:
www.waterrowerservice.com/troubleshooting
or contact WaterRower at support@waterrower.com