WEG CFW100 User Manual - page 28
Other manuals for CFW100:
Installation And Operation Manual, User Manual
of
120
CFW100 | 27
First Time Power-Up and Start-Up
E
ng
lis
h
The HMI display indicates:
Figure 5.1: HMI Display when powering up
5.2 START-UP
This section describes the power-up of the inverter with HMI operation, using the minimum
connections of
and without connections in the control terminals. Furthermore, two types
of control will be considered: V/f control (scalar) and vector control V V W. For further details on
the utilization of these types of control refer to the CFW100 programming manual.
DANGER!
High voltages can be present, even after the disconnection of the power supply.
Wait at least 10 minutes for full discharge.