WEG CFW100 User Manual - page 29
28 | CFW100
First Time Power-Up and Start-Up
E
ng
lis
h
5.2.1 Basic Application
Seq
Display Indication/Action
Seq
Display Indication/Action
1
2
Initialization Mode.
Press key
to enter the first level of the
parameterization mode.
Press keys
or
to select the parameter
P100.
Press key
if you need to change the content
of P100 – “Acceleration Time” or press key
for the next parameter.
3
4
If necessary, change the content of
“P101 – Deceleration Time”.
Use key
até selecionar o parâmetro P133.
If necessary, change the content of
“P133 – Minimum Speed”.
Press key
for the next parameter.
5
6
If necessary, change the content of
“P134 – Maximum Speed”.
Press key
for the next parameter.
If necessary, change the content of
“P135 – Output Maximum Current”.
Press key
to select parameter P002.
7
8
Press key
to view the parameter content.
Press key
that the motor will accelerate up
to 3.0 Hz (factory default setting of
P133 – Minimum Frequency).
Press
and hold it until it reaches 60.0 Hz.
9
10
Press key
. The motor will decelerate
to a stop.
When the motor stops, the display will indicate
“ready”.
Figure 5.2: Sequence for basic application