Wegner Crane CFW500 series Applications Manual - page 45
Parameters Description
Crane | 45
3.9.2 Horizontal
P0275 – DO1 Function
Adjustable
0 to 44 / 37 = Brake Release (Application Function 1)
Factory Setting: P0275 = 37
Range:
Proprieties:
Access groups via HMI:
I/O
Description:
This parameter define the function of the DO1 digital output. If the option “37 = Brake Release (Application
Function 1) has been selected, the output assumes the function of commanding the crane horizontal motion
brake. As presented in the section 2.3, the NO relay contact of DO1 digital output must be used.
NOTE!
Refer to the section 3.12.2 in this application manual for more information on the brake control logic.
NOTE!
Refer to the CFW500 programming manual for more information on the digital output parameters.
Some parameter options have been removed from the configuration wizard.
P0276 – DO2 Function
P0277 – DO3 Function
P0278 – DO4 Function
P0279 – DO5 Function
Adjustable
0 to 44 / 37 = Brake Release (Application Function 1)
Factory Setting: P0276 = 13
Range:
38 = Momentary Overload (Application Function 2)
P0277 = 11
40 = Torque Limitation (Application Function 4)
P0279 = 0
Proprieties:
Access groups via HMI:
I/O
Description:
These parameters define the functions of the DO2, DO3, DO4 and DO5 digital outputs. If the option “37 = Brake
Release (Application Function 1)”, has been selected, the output assumes the function of commanding the
crane horizontal motion brake. If the option “38 = Momentary Overload (Application Function 2)”, has been
selected, the output assumes the function of indicating the alarm “A770: Momentary Overload”. If the option “40
= Torque Limitation (Application Function 5)”, has been selected, the output assumes the function of indicating
the fault “F775: Inverter in Torque Limit”.
NOTE!
Refer to the section 3.12.2 in this application manual for more information on the brake control logic.
NOTE!
Refer to the CFW500 programming manual for more information on the digital output parameters.
Some parameter options have been removed from the configuration wizard.