Wegner Crane CFW500 series Applications Manual - page 82
Project Tree on WLP
Crane | 82
6.2 APPLICATION CONFIGURATION WIZARD
The Crane Vertical or Horizontal Motion application can be configured with the WLP software using the
configuration wizards, which consists of an oriented step by step guide for the configuration of the parameters
regarding the application.
NOTE!
When powering up the inverter for the first time follow the steps described in the chapter 5 “First
time Power-up and Start-up” of the CFW500 user´s guide inverter. It is recommended to use the
sensorless vector or the vector with encoder control mode for this kind of application
.
Figure 6.3 – Configuration wizard for Crane Vertical or Horizontal Motion application
6.2.1 Tittle
The page title indicates that the feature is covered.
6.2.2 Input Value for Parameters
The input values for the parameters are spaces where are inserted values of drive parameters. Only after
finishing the configuration wizard, the same will be sent to CFW500 frequency inverter.
6.2.3 Info
The info is to explain previously which of the selected parameter functionality, adjustable range and relevant
comments.
6.2.4 Browse Buttons
The configuration wizard has four kinds of browse buttons being:
■
Default: loads the default values of each parameter on the page in use;
■
Back: back to previous page;
■
Next: advance to the next page;
■
Cancel: close the configuration wizard without sending/save the values of the parameters edited.