XENO XNR44P User manual - page 26
User’s Manual | 24
The colors of the time bar are different, depending on the recording mode.
No color
- NONE
“NONE” means no recording by setup of schedule and recording.
Red color
- Instant recording
In continuous recording mode, the system records all the time as set by “CAMERA”.
Yellow color
- Continuous recording
Green color
- Motion-detection recording
In this mode, the system records only when motion is detected
In addition, users can set motion-recording configuration that can be set in camera menu and/or
network camera menu setting.
Orange color
- Sensor-activated recording
In sensor mode, the system will record when a sensor is triggered during the dwell time as set in
“SENSOR” of the “ALARM” menu. Sensor input can be selected between camera input sensor and
NVR input sensor. NVR input sensor is direct alarm input to NVR physically but Camera input sensor
is triggered by network. You should verify if specific network camera is integrated with NVR to
manufacturer.
Pink color
- Motion detection + Sensor-activated recording
The system does not record without motion and sensor event. Motion event data comes from
network camera can be set in “Camera” in “DEVICE” menu. This menu is for integrated network
camera setting and sensor type need to concluded in “Sensor” in “ALARM” menu.
If you set “OFF” in both “MOTION” and “SENSOR” in the “DEVICE” menu, then the system will
neither record nor notify the Advanced Client Software or Central Management System.
Light Blue color
- Continuous + Motion recording
In this mode, the system records as continuous recording mode when no motion is detected.
However, if only motion is detected, system starts recording as motion recording mode.
When continuous recording mode, the system records in 1frame per second and when motion
recording mode and the system will follow the camera setting value which you can set in record
setup menu.
*Record Setup is available only for approved camera models.