1. DL manuals
  2. Xerox
  3. Software
  4. 850DP - Phaser Color Solid Ink Printer
  5. Cleaning Instructions Manual

Xerox 850DP - Phaser Color Solid Ink Printer Cleaning Instructions Manual

Manual is about: Controller Software Version 10.0

Summary of 850DP - Phaser Color Solid Ink Printer

  • Page 1

    Phaser ® 850 color printer cleaning instructions 075-0580-00 october 1999 copyright © tektronix, inc. Unpublished rights reserved under the copyright laws of the united states. Contents of this publication may not be reproduced in any form without permission of tektronix, inc. Tektronix ® , phaser ®...

  • Page 2

    Cleaning instructions 1 cleaning phaser® 850 printers cleaning phaser ® 850 printers the printer should be cleaned when prints have oily streaks, stray ink or smeared ink. Cleaning may also be needed when paper is not picking reliably from the paper tray, or the pick and feed rollers are visibly dir...

  • Page 3

    2 phaser 850 color printer cleaning phaser® 850 printers cleaning for ink smears or jams: paper-feed rollers clean the paper-feed rollers if media feeds improperly, or if prints have ink smears. Caution hot surfaces exist behind the middle paper-feed rollers. To avoid personal injury during cleaning...

  • Page 4

    Cleaning instructions 3 cleaning phaser® 850 printers c. Scrub each roller thoroughly. If the wipe becomes dirty, discard it and use another. 5. The lower paper-feed rollers are located below the maintenance drawer (a): one set of rollers is black rubber; the other set is white plastic. To clean the...

  • Page 5

    4 phaser 850 color printer cleaning phaser® 850 printers cleaning for ink smears or jams: paper-exit path clean the paper-exit path if media feeds improperly, or if prints have ink smears. Caution to avoid damaging the print drum and rapid release guide, never use any sharp objects in this area, or ...

  • Page 6

    Cleaning instructions 5 cleaning phaser® 850 printers 4. Lift the blue paper guide to access the rapid release guide. 5. Lift up the blue tabs and remove the rapid release guide. 6. Gently wipe the clear plastic blade with a pre-soaked alcohol cloth. If the rapid release guide is damaged, replace it...

  • Page 7

    6 phaser 850 color printer cleaning phaser® 850 printers 7. Reinstall the rapid release guide, pressing down on the blue tabs to snap the blade into place. 8. Close the exit cover. Cleaning for media tray jams if the printer incorrectly feeds paper or transparencies, and the pick and feed rollers ar...

  • Page 8

    Cleaning instructions 7 cleaning phaser® 850 printers 3. Remove the maintenance drawer (a) from the printer. 4. The top of the media-pick roller is behind the black rubber paper-path rollers. To clean the top surface of the media-pick roller: d. Use a prepackaged alcohol-soaked cloth. E. Scrub the t...

  • Page 9

    8 phaser 850 color printer cleaning phaser® 850 printers cleaning for multipicks: separator pad if the printer picks multiple sheets of paper from the upper tray, clean the separator pad. 1. Remove the upper media tray from the printer. 2. Using an alcohol-soaked cloth, gently wipe the separator pad...