Xerox DocuMate 3125 User Manual - page 113
User’s Guide
7-105
7 Scanning from TWAIN and
WIA
Accessing the Scanner Interface
Every scanning application will access the scanner using a different method. Below is a brief list
of common applications and how to initiate a scan from within that application, including some
of the applications which may have been provided with your scanner. Please refer to the
application’s user guide for instructions on using the application and accessing the scanner.
•
Visioneer OneTouch
: Open the Visioneer OneTouch properties window and under the
configuration list select
Configure Before Scan
. Click on
OK
to save the changes and close
Visioneer OneTouch. The next time you scan using that button, the scanner interface will
open for you to set the scan options and start scanning.
•
Nuance PaperPort
: On the toolbar click on the scanner icon to open the scan pane on the
left side of the PaperPort desktop. Click on the
Select...
button to open the scanner
selection window. Select either the TWAIN or WIA driver for your scanner model and then
click
OK
. If you get a message that the scanner is not in the PaperPort database, follow the
instruction on-screen to run the Scanner Setup Wizard.
•
Nuance OmniPage
: Go to
Tools
, then select
Options...
. Click on the
Scanner
tab, then click
on
Setup
. Follow the instructions on-screen to setup OmniPage to work with the scanner.
Choosing TWAIN or WIA
A note about your scanner and the TWAIN standard:
TWAIN is a widely recognized standard that computers use to receive images from scanners
and digital cameras. The TWAIN scanning interface can be accessed from any TWAIN scanning
application you have installed on the computer. The driver interface described herein is the
TWAIN driver that has been developed for your scanner.
The interface described in this section is the one provided with your scanner and you will see it
when scanning from PaperPort or OmniPage. Other TWAIN compliant scanning applications
may also access this interface. However, there are some applications that have their own
TWAIN interface. If you are scanning from a software application, and see the interface shown
in this section, you can use these instructions to scan with the TWAIN interface. If you do not
see this TWAIN interface, please refer to your scanning application’s user guide for instructions.