Xerox DocuMate 3125 User Manual - page 151
Xerox
®
DocuMate
®
3125
Scanning from TWAIN and WIA
7-143
User’s Guide
Disabled Options in this Section
Some options in the interface may be grayed out and cannot be selected. Grayed out options
are either not appropriate for the current scanner, the software needed to enable the feature is
not installed,
or
the feature is dependent on another setting in the scanner's interface. Hover
the mouse cursor over a grayed out feature to see information about why the feature is
unavailable.
Module Configuration
When image processing modules are installed they will appear in the list on the
Configure
tab.
Use this tab to enable the modules you want to use when scanning.
There are some features in the scanner interface that are disabled until a module is installed
that contains those options. When the module is installed, the features will enable in the
scanner interface for you to use them.
Reordering the Modules
Select a module in the list and click the up or down arrow to change the order of the module in
the list. Changing the order of the modules changes the order in which the image processing
options are used. For example, if there are two modules installed and both modules include an
automatic image rotation option, the first module's rotate option is used and the rotate setting
in the second module is ignored so that the image is not rotated twice.
Scanner Configuration
The scanner configuration tab shows the hardware information for your scanner.
Power adjustments:
•
Sleep mode
—sleep mode is the low-power state when the scanner is not in use. You can
adjust the amount of time you want the scanner to wait before it goes into low power.
Click the green enter button to save any changes in the Sleep mode field.
Click the red reset button to reset to the default timeout value.
•
Turn lamp on
and
Turn lamp off
—click either of these buttons to immediately turn the
scanner lamp on or off.