Xerox DocuMate 3125 User Manual - page 41
Xerox
®
DocuMate
®
3125
Scanning and Configuring One Touch
6-33
User’s Guide
Note:
Use
Configure Before Scan
if you want to set the options manually before scanning. See
Configure Before Scan
on page 44.
Create a new configuration:
•
Click the
New
button to create a new configuration starting with the One Touch default
configuration settings.
•
Select a configuration in the list, then click on the
Copy
button to create a new
configuration starting with the settings of the currently selected configuration.
Edit or delete a configuration:
Select the scan configuration you want to edit or delete.
•
To delete the configuration, click the
Delete
button.
•
To edit the configuration, click the
Edit
button.
Edit the settings and click
OK
.
Note:
Your scanner comes with a number of configurations pre-set at the factory. To ensure
that your scanner will always have a set of correct scan configurations, do not delete the pre-set
configurations. We also recommend that you keep those configurations locked so they are not
inadvertently deleted. That way, you will always have the factory-settings available. If you do
delete or edit them, and want to get the factory pre-sets back again, you will need to uninstall
then re-install your scanner.
In the Scan Configuration Properties window, the
Scan Settings
,
Page Settings
,
Advanced
Settings
, and
Redaction Settings
tabs are always available. When the Visioneer Acuity module
is installed, the
Acuity Settings
tab will also be available for all destinations.
Based on the selected destination, additional settings tabs may also be available. If you see
one of these additional settings tabs please refer to the appropriate section, as listed below, for
instructions on configuring these destination specific options.
•
Use the
Storage Options
tab to choose the storage folder for scans sent to the Transfer to
Storage destination, as described on page 47.
•
Use the
Device Settings
tab to configure Fax and Print destinations, as described on
page 54.
•
Use the
PaperPort
tab to choose the destination folder, in the Nuance PaperPort
application, as described on page 55.
•
Use the
SharePoint
tab to specify a SharePoint site, user credentials, and destination
folder, as described on page 57.
•
Use the
FTP Transfer
tab to specify an FTP site, user credentials, and destination folder, as
described on page 60.
•
Use the
SMTP Configuration
tab to specify an SMTP server, user credentials, and
destination email address, as described on page 63.