Xpresskit DBALL2 Installation Manual - page 12
Module Programming
Page 12
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 (and higher) or the Directechs Mobile app.
When the flashing operation is successful, you can proceed with the programming instructions below.
Refer to the LED Diagnostics section on pages 15-16 for more information and for troubleshooting purposes.
OR
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
D2D Installation
W2W Installation
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
10-pin
D2D
st
1
12-pin
14-pin
nd
2
rd
3
10-pin
D2D
st
1
th
4
12-pin
14-pin
nd
2
rd
3
4
5
3
1
Solid
You have successfully completed the module programming sequence.
Wait until the LED turns ON solid red.
Press the Push-to-Start (PTS) button once to turn the ignition
ON. The LED flashes orange then flashes green.
Solid green x
3 secs
Off
&
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the Flash Module button.
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH button.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your XKLoader3.
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select FLASH YOUR MODULE and follow the on screen
instructions.
The LED will then turn ON solid green for 3 seconds and shut OFF.
Press the Push-to-Start (PTS) button once to turn the ignition OFF.
1X
ENGINE
START
STOP
PUSH
1X
ENGINE
START
STOP
PUSH
&
Flashes
orange
&
Flashes
green
2
Press the Unlock button on the OEM remote.
Rev.: 20171012
Platform: DBALL2
Firmware:
VW06
© 2017 Directed. All rights reserved.