Xpresskit DBALL2 Installation Manual - Remote
1: Green: (-) Lock Input
2: Blue: (-) Unlock Input
9: Pink: (+) Ignition Input
10: Blue/White: (-) GWR (Status) Input
(-) GWR (Status)
(+) Ignition Output
(-) Lock Output
(-) Unlock Output
[2]
Key Wrap: Brown/Red: 12
[2]
Key Wrap: Yellow/Red: 11
[2]
Key Wrap: Orange/Red: 10
(-) Ground: Black: 14
(-) Ground
(+) 12V: Red: 13
(+) 12V
(-) PTS 1 Output: Green/Black: 2
(-) Door Status Output: Green/White: 3
[1]
(AC) Tach Output: Violet/White: 5
(-) Trunk Status Output: Red/Black: 4
(-) Hazard Light Output: Black/White: 1
(-) Hood Status Output: Blue/Red: 12
(+) Brake Status Output: Gray: 6
(+) Ignition Status Output: Gray/Black: 7
(-) PTS 2 Output: Violet/Brown: 9
(-) Door Status Input
[1]
(AC) Tach Input
(-) Hood Status Input
(+) Ignition Status Input
1
13
12
73
38
63
(-) Trunk Status Input
HS CAN 1 High: Tan/Black: 3
HS CAN 1 Low: Tan: 4
HS CAN 2 High: Orange/Green: 5
HS CAN 2 Low: Orange/Brown: 6
8
16
OBDII
Diagnostic
Connector
PTS Switch
(black connector
at start/stop button)
1
9
HS CAN 1 High: Red, pin 6
HS CAN 1 Low:
Orange/Brown, pin 14
(-) PTS 1:
Blue/White, pin 3
2
5
1
4
3
6
(-) PTS 2:
Blue/Yellow, pin 6
HS CAN 2 High:
Lt. Green, pin 16
HS CAN 2 Low:
Orange/Brown,
pin 17
(+) 12V Input
(+) 12V:
Red/Gray, pin 1
A1
A2
A3
3: Red/White: (-) Trunk Release Input
(-) Trunk Release Output
Remote
Starter
VESCM: Vehicle Electrical
System Control Module
(high above drivers kick)
(+) Brake Status Input
37 62
(+) Brake:
Black/Red,
pin 58
(-) Hazards:
Violet/Red
pin 42
(+) Starter Output
1
13
12
37 62
73
38
63
(-) Ground
Not required in D2D mode.
White VESCM Connector A3
(above drivers kick)
(-) Trunk/Hatch
Release:
Gray/Green,
pin 32
(-) Trunk/Hatch Release Output
P#: XKD2D65
TX
(-) Ground
RX
(+)12V
10
RF
Prog. Button
LED
4
14
12
2
DBALL2
Black VESCM Connector A1
(above drivers kick)
Page 5
Installation Type 2
[1]
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
[2]
For Key Wrap instructions refer to pages 9-10.
Rev.: 20171012
Platform: DBALL2
Firmware:
VW06
© 2017 Directed. All rights reserved.