Xpresskit DBALL2 Installation Manual - Xl202
© 2017 Directed. All rights reserved.
Platform: DBALL2
Firmware GM10 Range Extender Ready (RXT) Installation
:
Rev.: 20 70
1
821
SmartStart/
202 Installation Notes
XL
Page 11
Th
solution offers t
( ) configuration options to control your system
Kit or
e
Range Extender Ready (
)
wo 2
:
DBALL
RXT
RF
both
This section provides specific installation information for SmartStart and
202.
SmartStart (
sold separately).
XL
The
202 and antenna are not included and
be purchased separately.
optional XL
MUST
Refer to the Passive Keyless Entry (
) Installation Guide (N2102T) for detailed wiring information.
PKE
4
4
XL202
Antenna
XOVER
SmartStart is
and not included. It
be purchased separately.
optional
MUST
SmartStart is
and not included. It
be purchased separately.
optional
MUST
Configuration Wires (Gray & White)
Connect Gray wire to (-) Ground
5 pins
D2D (4 pins, white)
4 pins
2 pins,
not used
CABLE
CABLE
The modules must be connected in a specific order. Refer to the
section for more information.
Module Programming
1. Use the D2D Crossover (
) cable that is provided with
202, and
the one in the
package.
XOVER
XL
NOT
DBALL
2. The modules must be connected in a specific order. Refer to the
section for more information.
Module Programming
The modules must be connected in a specific order. Refer to the
section for more information.
Module Programming
SmartStart Revision B
RF Kit
RF
PKE
&
Combination
Kit
Refer to the Passive Keyless Entry (
) Installation Guide (N2102T) for detailed wiring information.
PKE
RF
PKE
BT
,
& SmartStart
Combination
Kit
SmartStart Revision A
DBALL/
2
DBALL
DBALL/
2
DBALL
DBALL/
2
DBALL
LED
Prog.
Button
D2D (4 pins, white)
4 pins
2 pins,
not used
OR
SmartStart
Configuration Wires (White & Brown or Blue)
Cut Brown or Blue Loop
LED
THIS SIDE UP
LED