Xpresskit DBALL2 Installation Manual - page 14
Page 14
Feature
Option List
&
It is recommended to configure all
features and options listed below
the
the
using
configuration tool found on the module flashing page
on www.directechs.com. The web offers more options such as
; however, manual configuration of the features is possible using
RSR
the information on this page.
Feat.
Operation
Flashes/Option
Description
1. No RF
Output*
Module is connected to a remote starter using a standard installation.
2. RFTD Output Module is connected to an XL202 using an RSR or RXT installation (when available).
3. SmartStart
Module is connected to SmartStart using an RSR or RXT installation (when available).
1. Driver
priority*
Unlocks only the driver door when the button is first pressed, and unlocks all doors when it is
pressed a second time within 5 seconds.
2. All
Unlocks all doors when the button is first pressed.
1. Disabled*
No action.
2. Enabled for
Windows
Module will perform windows roll up upon lock command.
3. Enabled for
Windows and
Sunroof
Module will perform windows roll up and close sunroof upon lock command.
1. Disabled*
No operation.
2. Enabled
When the feature is enabled, it will activate the Heated Seats and heated steering wheel.
1. 32°F (0°C)*
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start
when temperature is below 32 °F (0 °C).
2. 23°F (-5°C)
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start
when temperature is below 23 °F (-5 °C).
3. 41°F (+5°C)
When Heated Seats or Defroster feature is enabled, it will activate the feature upon remote start
when temperature is below 41 °F (5 °C).
4. Always ON
When Heated Seats or Defroster feature is enabled, it will activate the feature at any temperature.
1. Disabled
The OEM alarm will not be controlled by the interface upon remote start. No disarm or arm
command will be executed at the beginning or end of the sequence; it must be controlled by the
Remote Starter.
2. Safelock
Smart OEM Alarm Control will behave like a standard Safelock feature on a remote starter. It will
unlock at the beginning of the sequence, and relock after start and shutdown.
3. Enabled*
Smart OEM Alarm Control will synchronize with the OEM alarm so that it will disarm and rearm the
vehicle in the remote start sequence, only when required. Smart OEM Alarm Control will monitor
the alarm and door lock status to detect if the disarm or rearm is required. If the vehicle is unlocked
or is not equipped with factory alarm, the disarm/rearm will not be executed.
Smart OEM Alarm
Control
6
Heated
Seats/Defroster
Temperature Control
5
* Default Option
RFTD Output Type
1
Unlock Driver Priority
4
Comfort Closure with
Lock
3
2
Heated Seats
© 2017 Directed. All rights reserved.
Platform: DBALL2
Firmware GM10 Range Extender Ready (RXT) Installation
:
Rev.: 20 70
1
821