Xpresskit DBALL2 Installation Manual - page 12
Page 12
Module Programming
2
3
5 times on the programming button
Press
then
the key to the
turn
IGN
position.
The
orange for 3 seconds
.
LED turns
solid
, then shuts
ON
OFF
&
&
Solid x3 Secs
Off
Press X5
Key IN
OFF
START
IGN
You have successfully completed the module programming sequence.
1
10-pin
D2D
1
st
12-pin
14-pin
2
nd
3
rd
&
Solid
Connect the 10-pin
2-pin
harnesses to
, 1
and 14-pin
DBALL, then w
.
ait until the
turns
solid red
LED
ON
Refer to the
Diagnostics section on page 16 for more information and for troubleshooting purposes.
LED
Important
10-pin
D2D
XL202
10-pin
D2D
SmartStart
OR
The
module
be disconnected from any power source before SmartStart can
DBALL
must
be connected to it. Failing to do so could damage
.
DBALL
a.
To e
nsure that the D2D communication between SmartStart and
works properly, the
DBALL
Gray wire must be connected to a ground source (
SmartStart), and the Brown or Blue
Rev B
loop must be cut (
SmartStart).
Rev A
b.
Do
connect the 2-pin harness (on SmartStart). Power and ground will be provided by
NOT
the
D2D connector.
DBALL
Connect SmartStart to
using the D2D port.
DBALL
SmartStart Installation
Connect
202 to
using the D2D port.
XL
DBALL
XL202 Installation
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Note: Before connecting either the
202 or SmartStart module to
, it is important to ensure that the proper feature and
XL
DBALL
function programming is selected using Xpress
(version 4. or higher). Visit www.directechs.com to download the latest
VIP
5
version of the application.
Warning!
To take advantage of advanced features, you must use Xpress
4.5 (and higher) or the Directechs Mobile app.
VIP
When the flashing operation is successful, you can proceed with the programming instructions below.
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the
button.
Config for RXT
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH button.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your
oader3.
XKL
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select
and follow the on screen
FLASH YOUR MODULE
instructions.
© 2017 Directed. All rights reserved.
Platform: DBALL2
Firmware GM10 Range Extender Ready (RXT) Installation
:
Rev.: 20 70
1
821