Xpresskit DBALL2 Installation Manual - page 19
Quick Reference Guide
DBALL2-
Range Extender Ready (RXT) Installation
GM10
© 2017 Directed. All rights reserved.
Range Extender Ready (
) is used to amplify the distance covered
RXT
by factory remote starters, which are built into the
of the vehicle.
BCM
The interface connects to the vehicle and uses the same codes as the
factory remote to remote start the vehicle. The runtime and features are
identical to the ones for the
remote starter. Some of the
OEM
advantages of
are greater distance coverage and 2-way
RXT
compatibility.
Range Extender Ready (
)
RXT
Command
Engine
Result
Start
NOT running.
The engine will be started (runtime 10 minutes).
Start
Running.
The engine will be stopped.
The following table describes the behavior of the vehicle in relation to the RXT
feature. The following commands are performed on the aftermarket remote.
Runtime
T
equivalent to the amount set for the
,
he runtime is
remote starter which is 10
OEM
minutes. A maximum of 2 remote start can be performed between ignition cycle .
s
s
Runtime Reset
T
s
he Runtime Reset feature allow the user to increase the runtime duration for a
maximum of 10 minutes. This can only performed
per remote start.
ONCE
RXT Operations
Button(s)
Actions
Press & hold for 1 second to lock.
Press & hold for 1 second to unlock.
Press & hold for 1 second to remote
start.
Press & hold for 5 seconds to activate
the trunk release (optional).
Press
once, then
to activate the
rear hatch/tail glass release (optional).*
Press
3 times, then
to activate
the panic mode.
Press
once, then
to reset the
remote starter runtime.
List of Available Commands
x1 +
x3 +
x1 +
* This output is configurable. see your authorized installation center for more
information.
Note that the information below is for Viper, Clifford and Python models. Icons and
commands may differ depending on the remote brand and model purchased. Refer
to your authorized installation center for more information.
Note: Due to
limitations, the remote starter will not activate if “Check
OEM
Engine” indicator or
(Diagnostic Trouble Code) is present, or if the hood is
DTC
open or if 2 remote start were done without inserting the key to ignition
.
ON