Xpresskit DBALL2 Installation Manual - page 12
Quick Reference Guide
DBALL2-CHRYSLER10
© 2016 Directed. All rights reserved.
Vehicle Takeover
5
3
1
Close the vehicle doors, hood and trunk, then press
the Remote Start button on the transmitter to start
the vehicle.*
2
Press the brake pedal, put the car
in gear and drive off.
Enter the vehicle, while making sure the
factory remote is inside with you.
Press the Unlock button on the factory
or aftermarket remote.*
Ready to
drive off
Press
remote start
button*
Press Unlock
button on
either remote*
OR
* Your aftermarket remote may differ from the model shown in the illustrations.
Enter vehicle
with key fob
PA
NIC
x2
x2
PANIC
x2
x2
Button(s)
Actions
Press & hold for 1 second to lock.
Press & hold for 1 second to unlock.
Press & hold for 1 second to remote
start.
Press & hold for 5 seconds to activate
the trunk release (optional).
Press once, then to activate the
rear hatch/tail glass release (optional).*
Press 3 times, then to activate
the panic mode.
Press once, then to reset the
remote starter runtime.
List of Available Commands
x1 +
x3 +
x1 +
* This output is configurable. see your authorized installation center for more
information.
Note: There is no vehicle Pit Stop/Idle Mode in this firmware.
Note that the information below is for Viper, Clifford and Python models. Icons and
commands may differ depending on the remote brand and model purchased. Refer
to your authorized installation center for more information.
4
Press the PTS button twice to turn the
ignition ON.
Important: Do NOT press the brake pedal.
2X
ENGINE
START
STOP
PUSH
Do NOT press
brake pedal