Xpresskit DBALL2 Installation Manual - page 5
Module Programming
Page 5
4
Press on the Start/Stop button (PTS) once more to turn the ignition OFF.
ENGINE
START
STOP
PUSH x1
3
Press on the Start/Stop button (PTS) twice to turn the ignition ON ("RUN"
illuminates on Start/Stop switch). The LED will flashes orange slowly.
Note: If transponder programming was skipped, the LED turns ON solid orange
for 3 seconds then shuts off once the module is successfully programmed
without bypass. Press the PTS button once to switch the vehicle OFF.
Refer to the LED Diagnostics section for more information and for troubleshooting purposes.
To use this firmware as convenience only, you can skip the bypass by
pressing the programming button 5 times.
2
Press x5
&
Flash
slowly
ENGINE
START
STOP
PUSH x2
PA
NIC
x2
x2
1
Solid
Wait until the LED turns ON solid red.
Note: To skip the transponder programming and use convenience features only, press
the programming button 5 times. The LED will turn orange then proceed to step 2.
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 (and higher) or the Directechs Mobile app.
When the flashing operation is successful, you can proceed with the programming instructions below.
OR
If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to
the module, then connect the 4-pin D2D harness.
D2D Installation
W2W Installation
If required for your installation, connect the 10-pin and 12-pin harnesses to the
module, then connect the 14-pin harness to the module.
10-pin
D2D
st
1
12-pin
14-pin
nd
2
rd
3
10-pin
D2D
st
1
th
4
12-pin
14-pin
nd
2
rd
3
Flashing a module using your computer:
1. Connect the interface module to your computer using the
XKLoader2.
2. Go to www.directechs.com using Internet Explorer, and
select the Flash Module button.
3. Follow the instructions to select your vehicle, installation
type, and configure your options.
4. Once you have configured the firmware options, click on the
FLASH button.
Flashing a module using your smartphone or tablet
1. Connect the interface module to your XKLoader3.
2. Launch the Directechs Mobile app on your smartphone or
tablet.
3. Select FLASH YOUR MODULE and follow the on screen
instructions.
5
Disconnect the module and complete the Key2GO programming.
Go to the next page to complete the module programming.
Rev.: 20160201
Platform: DBALL2
Firmware:
CHRYSLER10
© 2016 Directed. All rights reserved.
Wire jump template
You have successfully completed the module programming sequence.
Once the configuration is completed, reconnect the module.
The LED turns solid green for 3 sec. then OFF.
Click on Submit Key2GO Request.
Remove the DBALL from the vehicle and reconnect it to your computer. The Directechs web site will
automatically recognize that you are moving onto the second phase of the programming sequence.
Solid
x3 sec.
Off
7
6
5