Xterra FS3.0 Owner's Manual - Pedal Arms Assemblies
8
FS3.0 Elliptical
#29. 1/2” x 70mm
Carriage Bolt (2 pcs)
#30. 1/2”
Nyloc Nut (2 pcs)
#44. 5/16” Flat
Washer (2 pcs)
#46. 5/16”
Split Washer (2 pcs)
#52. 5 x 12mm
Sheet Metal Screw
(2 pcs)
#98. 5/16” x 1”
Button Head Socket
Bolt (2 pcs)
Pedal Arms Assemblies
4
Hardware Step 4
1. Locate the Right side Pedal Arm Assembly (
2) and install onto the
pedal axles’ large rotating wheel at the rear of the elliptical. Attach with
one Button Head Socket Bolt (
98), one Split Washer (46) and one Flat
Washer (
44). Use the M5 Allen Wrench (68) to tighten.
2. Locate the Carriage Bolt (
29) and slide it through the bracket at the front
of the Pedal Arm Assembly (
2) and Lower swing arm (6). Fasten a Nyloc
Nut (
30) to the carriage bolt (29) with the 19mm Wrench (69).
3. Attach the Pedal Arm Covers (
85, 86) onto the Pedal Arm Assembly (2)
with one Sheet Metal Screw (
52). Tighten using the Phillips Head Screw
Driver (
68).
4. Attach Rear Cover (
125) onto the Pedal Arm Assembly (2) with one Phil-
lips Head Screw (
53). Tighten with Phillips Head Screw Driver (68).
5. Repeat the steps above for the left side pedal arm assembly.