Xterra FS3.0 Owner's Manual - Left Swing Arm
FS3.0 Elliptical
7
#43. 5/16” x 3/4”
Button Head Socket
Bolt (1 pc)
#52. 5 x 12mm
Sheet Metal Screw
(4 pcs)
#55. 5/16”
Nyloc Nut (2 pcs)
#56. 5/16” x 1-3/4”
Button Head Socket
Bolt (2 pcs)
#100. 8.5 x 23 x 1.5T
Flat Washer (1 pc)
3
Hardware Step 3
Left Swing Arm
1. Locate the Left Swing Arm (Upper) (
7) and slide it through the Swing
Arm Bushing (
23); secure it to the Lower swing arm (5) with two Button
Head Socket Bolts (
56) and two Nyloc Nuts (55). Tighten using M5 Allen
Wrench (
68).
2. Slide the Handle Bar Cover (
78) and Lower swing arm (5) over the
Swing Arm Axle (
22). Attach with one Button Head Socket Bolt (43) and
one Flat Washer (
100). Tighten using the M5 Allen Wrenches (68).
Note: It is important to use two Wrenches (68), one on each end of the
Axle (
220), when tightening the Bolts (43).
Note: If there is a gap after assembling the swing arm, please install a
C-ring at Location B as shown above.
3. Install the outer covers (
79) with four Sheet Metal Screws (52). Tighten
using the Phillips Head Screw Driver (
68).