Yamaha FZ6-ST Supplementary Service Manual - Spec
SPEC
7
To the rear turn signal light (left)
Pass the fuel tank drain hose through the clamp
located under the coolant reservoir tank.
Route it behind the starter motor lead.
Point the bend-R section of the throttle cable
(pull side) to the inner side horizontally. It is also
possible to visually check the bend-R section.
To the headlight lead.
Point the tip of the clamp to the inner side of the
vehicle body.
Make sure to pass the neutral switch lead
through the hole of the flap.
Clamp the seat lock wire to the frame as shown
in the illustration. Secure the clamp to the weld
of the cross member with the frame. Position the
binding section in front of the vehicle body and
cut the tip to be between 1 and 5 mm (0.04 and
0.20 in).
Install the clamp with its ends facing between
the downward or forward position.
CABLE ROUTING