Yamaha FZ6-ST Supplementary Service Manual - Spec
SPEC
9
Either right or left side arrangement for the left
handlebar switch lead coupler and radiator fan
motor coupler can be accepted.
Point the L-shape terminal to the front side of
the vehicle.
Hook the starter motor lead to the alternate
pawls on the battery cover.
Route the crankshaft position sensor lead above
the starter motor leads.
To the crankshaft position sensor.
Clamp the starter motor lead and crankshaft
position sensor lead. Point the projected part of
the tip to the inner side of the vehicle.
Pass the radiator hose, coolant reservoir hose,
wire harness and starter motor lead in order
through the lower side of the vehicle.
Set the 4-pin coupler in the connector cover
after wiring it.
To the sidestand switch.
To the speed sensor.
To the A.C. magneto.
To the oil level switch.
To the tail/brake light switch.
To the neutral switch.
Push the wire harness in the groove of the mud
guard.
Point the opening section of the clamp upward.
To the rear turn signal (right)
To the rear turn signal (left)
To the license plate light.
To the tail/brake light.
CABLE ROUTING