Yamaha FZ6-ST Supplementary Service Manual - Chas
4-30
FRONT AND REAR BRAKES
CHAS
a
WARNING
NOTE:
30 Nm (3.0 m
Skg, 22 ftSlb)
WARNING
CAUTION:
EAS00598
ASSEMBLING AND INSTALLING THE
FRONT BRAKE MASTER CYLINDER
SBefore installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
SNever use solvents on internal brake com-
ponents.
Recommended brake fluid
DOT 4
1. Install:
Smaster cylinder kit
Scirclip
New
Sbrake master cylinder
1
SInstall the brake master cylinder holder with
the “UP” mark facing up.
SAlign the end of the brake master cylinder
holder with the punch mark
a
on the handle-
bar.
SFirst, tighten the upper bolt, then the lower bolt.
2. Install:
Scopper washers
1
New
Sbrake hose
2
Sunion bolt
3
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
“CABLE ROUTING” in chapter 2.
When installing the brake hose onto the
brake master cylinder, make sure that the
brake pipe touches the projection
a
on the
brake master cylinder.