Yamaha FZ6-ST Supplementary Service Manual - Eng
Other manuals for FZ6-ST:
Supplementary Service Manual, Owner's Manual
of
469
5-82
CONNECTING RODS AND PISTONS
ENG
WARNING
CAUTION:
NOTE:
b. Clean the connecting rod bolts and nuts.
c. Tighten the connecting rod nuts.
d. Put a mark
1
on the corner of the connecting
rod nut
2
and the connecting rod cap
3
.
e. Tighten the nut further to reach the specified
angle (150
_).
When the nut is tightened more than the spe-
cified angle, do not loosen the nuts and then
retighten it.
Replace the bolt and nut with a new one and
perform the procedure again.
SDo not use a torque wrench to tighten the
nut to the specified angle.
STighten the nut until it is at the specified
angles.
When using a hexagonal nut, note that the
angle from one corner to another is 60
_.