Yamaha FZ6-ST Supplementary Service Manual - Elec
8-12
IGNITION SYSTEM
ELEC
EAS00752
11. Sidestand switch
S Check the sidestand switch for continuity.
Refer to “CHECKING THE SWITCHES”.
S Is the sidestand switch OK?
YES
NO
Replace the side-
stand switch.
EAS00763
12. Clutch switch
S Check the clutch switch for continuity.
Refer to “CHECKING THE SWITCHES”.
S Is the clutch switch OK?
YES
NO
Replace the clutch
switch.
13. Starting circuit cut-off relay (diode)
S Disconnect the starting circuit cut-off relay
coupler from the wire harness.
S Connect the pocket tester (Ω 1) to the
starting circuit cut-off relay coupler as
shown.
S Check the starting circuit cut-off relay for
continuity.
Positive tester probe
!
black / red
Negative tester probe
!
sky blue
1
2
EAS00753
Positive tester probe
!
black / red
Negative tester probe
!
blue / green
Continuity
1
3
Positive tester probe
!
sky blue
Negative tester probe
!
black / red
2
1
Positive tester probe
!
blue / green
Negative tester probe
!
black / red
No
continuity
3
1
YES
NO
Replace the starting
circuit cut-off relay.
When you switch the positive and negative
tester probes, the readings in the above chart
will be reversed.
S Are the tester readings correct?
NOTE:
14. Lean angle cut-off switch
S Check the lean angle cut-off switch.
Refer to “FUEL INJECTION SYSTEM” in
chapter 7.
S Is the lean angle cut-off switch OK?
YES
NO
Replace the lean
angle cut-off switch.