3Com CoreBuilder 2500 User Manual - page 165
Setting SAP Triggered Updates
12-11
Setting SAP
Triggered Updates
The
ipx sap triggered
command directs the IPX protocol when to
broadcast newly learned SAP server addresses.
Default
The default setting is
enabled
.
To configure IPX SAP broadcast timing:
1
From the top level of the Administration Console, enter:
ipx sap triggered
2
Enter the triggered update mode:
■
disabled
— IPX broadcasts SAP server addresses 3 seconds after
learning them.
■
enabled
— IPX broadcasts SAP server addresses immediately after
learning them.
Example:
Enter Trigger Update mode for SAP (disabled,enabled) [enabled]:
Displaying Statistics
Use this command to display IPX summary, RIP, SAP, and forwarding
statistics from the Administration Console.
Displaying IPX
Summary Statistics
To display IPX summary statistics, from the top level of the Administration
Console, enter:
ipx statistics summary
This example shows IPX summary statistics:
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧
ipx
appletalk
snmp
analyzer
script
logout
interface
route
server
forwarding
rip
➧
sap
statistics
mode
➧
triggered
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
➧
ipx
appletalk
snmp
analyzer
script
logout
interface
route
server
forwarding
rip
sap
➧
statistics
➧
summary
rip
sap
forwarding
IPX forwarding is enabled, RIP is active, SAP is active,
RIP Trig enabled, SAP Trig enabled
Received Transmitted Dropped Msg Pool Empty
1170878 565099 0 0