3Com CoreBuilder 2500 User Manual - page 200
14-4
C
HAPTER
14: A
DMINISTERING
A
PPLE
T
ALK
R
OUTING
Removing an
Interface
Use this command to remove an interface when you no longer perform
routing on the ports that are associated with the interface.
To remove an interface:
1
From the top level of the Administration Console, enter:
appletalk interface remove
2
Enter the index numbers of the interfaces you want to remove.
The interfaces are no longer defined on the router.
Administering
Routes
Your system maintains a table of routes to other AppleTalk networks. The
Routing Table Maintenance Protocol (RTMP) automatically generates the
routing table. RTMP defines rules for:
■
Information contained within each routing table
■
Exchanging information between routers so that the routers can
maintain their routing tables
Each routing table entry contains the following information:
■
Network Range
— A range of numbers used to designate a network
segment’s identity
■
Distance
— The distance in hops to the destination network
■
Interface
— The defined interface number
■
State
— The status (
good, suspect, bad,
or
really bad
) of each
route
Displaying the
Routing Table
Use this command to display the system’s routing tables to determine the
routes that are configured and whether they are operational.
To display the contents of the routing table, from the top level of the
Administration Console, enter:
appletalk route display
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
ipx
➧
appletalk
snmp
analyzer
script
logout
➧
interface
route
aarp
zone
forwarding
checksum
ping
statistics
display
define
➧
remove
Top-Level Menu
system
ethernet
fddi
atm
bridge
ip
ipx
➧
appletalk
snmp
analyzer
script
logout
interface
➧
route
aarp
zone
forwarding
checksum
ping
statistics
➧
display
flush