3Com CoreBuilder 2500 User Manual - page 36
2-4
C
HAPTER
2: VLAN
S
ON
THE
C
ORE
B
UILDER
2500 S
YSTEM
Table 2-1 lists the protocol suites that the CoreBuilder 2500 supports, as
well as the protocol types included in each protocol suite.
Switch Ports
A group of switch ports is any combination of ports on a
CoreBuilder 2500 system bridge. Included are switch ports created as
ATM LAN Emulation Clients (ATM LECs). VLANs support only media
implementations that run over switch (bridge) ports, for example, ATM
Logical IP Subnets (ATM LISs).
Layer 3 Addressing Information
For IP VLANs only, the CoreBuilder 2500 system optionally supports
configuring of individual IP VLANs with network layer subnetwork
addresses. With this additional Layer 3 information, you can create
independent IP VLANs that share the same switch ports for multiple IP
VLANs. To distinguish among multiple IP VLANs on the same switch port,
the CoreBuilder 2500 system floods data according to both the protocol
(IP) and the Layer 3 information in the IP header. This configuration is
discussed on page 2-7 in “Overlapped IP VLANs.”
Table 2-1
Supported Protocols for VLAN Configuration
Protocol Suite
Protocol Types
IP
IP, ARP, RARP (Ethernet II)
Novell IPX
IPX (Ethernet II, 802.2, 802.3, 802.3 SNAP)
AppleTalk
DDP, AARP (Ethernet II, 802.3 SNAP)
Xerox XNS
XNS IDP, XNS Address Translation, XNS Compatibility
(Ethernet II, 802.3 SNAP)
DECnet
DEC MOP, DEC Phase IV, DEC LAT, DEC LAVC
(Ethernet II, 802.3 SNAP)
SNA
SNA Services over Ethernet (Ethernet II, 802.2,
802.3 SNAP)
Banyan VINES
Banyan (Ethernet II, 802.3 SNAP)
X25
X.25 Layer 3 (Ethernet II, 802.3 SNAP)
NetBIOS
NetBIOS (802.2)
Default
Default (all protocol types)