3Com CoreBuilder 2500 User Manual - page 180
13-12
C
HAPTER
13: A
DMINISTERING
OSPF R
OUTING
Setting Costs
The interface cost reflects the line speed of the port. Although the system
calculates a default cost value based on the module media type, you can
manually change the cost to a different value. In most cases, you can
accept the system default value.
To set the interface cost:
1
From the top level of the Administration Console, enter:
ip ospf interface cost
2
Enter an IP interface.
3
Enter the cost value for the interface.
The default is calculated by the system.
Allowable values:
1
through
65535
.
Setting
Transmit Delays
This command sets the OSPF interface transmit delay, in seconds. The
system adds the value of the transmit delay to all link state
advertisements (LSAs) that it sends out to the network. Set the transmit
delay according to the link speed: use a longer transmit delay time for
slower link speeds.
Default
The default delay is
1
second.
To set the interface delay:
1
From the top level of the Administration Console, enter:
ip ospf interface delay
2
Enter an IP interface.
3
Enter the interface transmit delay value.
Range:
1
through
65535
seconds.
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧
ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
routing
icmpRouterDiscovery
➧
ospf
rip
ping
statistics
areas
defaultRouteMetric
➧
interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
summary
detail
statistics
mode
priority
areaID
➧
cost
delay
hello
retransmit
dead
password
Top-Level Menu
system
ethernet
fddi
atm
bridge
➧
ip
ipx
appletalk
snmp
analyzer
script
logout
interface
route
arp
multicast
udphelper
icmpRouterDiscovery
➧
ospf
rip
ping
statistics
areas
defaultRouteMetric
➧
interface
linkStateData
neighbors
routerID
partition
stubDefaultMetric
virtualLinks
statistics
summary
detail
statistics
mode
priority
areaID
cost
➧
delay
hello
retransmit
dead
password