3D Systems ProX DMP320 User Manual - page 43

43

3D SYSTEMS, INC

.

Feed/build Platform Movements

1

2

1

3

4

5

6

1 .  Move platform up/down to the end position (home) .

Note: it is required to home the platforms from time to time to ensure accurate position display . When a long time 

has passed since the last homing a warning symbol will remind you to perform a homing again .

CAUTION: when the feed or build module is moved fully up while still containing powder, this powder will be spilled 

inside the process chamber . To stop automatic movement, press the escape button on the keyboard .

2 .  Move platform up/down until button is released .

3 .  Move platform up/down with a set amount of µm as can be filled in in the textbox above.

4 .  Machine position gives the current position of the platform with the top position as 0 µm .

5 .  User position is the platform position that can be zeroed at any location by the user by clicking on it .

6 .  When this button is pressed, the applicable feed platform will move to the same machine position as the other feed platform .

7 .  When this option is marked, the platform will move up/down at a faster rate . (while printing, this option is disregarded) .

Tip: When the shift button is held while pressing one of the buttons of a feed platform, both feed platforms will perform the same 

action .

Actions

Prepares the printer to start printing .

Releases the pressure from the process chamber, This 

allows the user to open the door and unload the build .

7