3D Systems ProX DMP320 User Manual - page 82
of
83
82
3D SYSTEMS, INC
.
DMP DEPOSITION
Fix ‘Unsafe filter pressure’ message.
An automatic solution is available in DMP Deposition software from version v21 .0 .0 onwards .
Detecting of Job Processing Capability Failed after Restart of DMP Deposition .
Available in DMP Deposition software from version v21 .0 .20 onwards .
1 . When the DMP Deposition program starts, it verifies if the right machine conditions are met to allow for a job start. If the machine
conditions are met, the ‘Run job’ button can be pressed.
2 . If this detection failed during program start, go to menu Controllers > Verify if ready for processing . This will repeat the evaluation .
After successful verification, you can press the ‘Run job’ button again.