3xLogic VSX-1.3MP-PIR1 User Manual - page 40
User Manual|
VISIX Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
40
Figure 6-‐18
Email Settings
3) Configure the following settings:
!
Sender: The name of the email sender.
!
Sender’s Address: The email address of the sender.
!
SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
!
SMTP Port: The SMTP port. The default TCP/IP port for SMTP is 25 (not secured). And the SSL
SMTP port is 465.
!
Enable SSL: Check the checkbox to enable SSL if it is required by the SMTP server.
!
Attached Image: Check the checkbox of Attached Image if you want to send emails with attached
alarm images.
!
Interval: The interval refers to the time between two actions of sending attached pictures.
!
Authentication (optional): If your email server requires authentication, check
!
this checkbox to use authentication to log in to this server and enter the login user Name and
password.
!
Choose Receiver: Select the receiver to which the email is sent. Up to 2 receivers can be
configured.
!
Receiver: The name of the user to be notified.
!
Receiver’s Address: The email address of user to be notified.
4) Click Save to save the settings.
CONFIGURING NAT (NETWORK ADDRESS TRANSLATION) SETTINGS
Purpose:
1) Enter the NAT settings interface.
Configuration >Advanced Configuration >Network > NAT
2) Choose the port mapping mode.
To port mapping with the default port numbers: