3xLogic VSX-1.3MP-PIR1 User Manual - page 67
User Manual|
VISIX Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
67
If you select Motion & Alarm, the video will be recorded when the motionandalarm are
triggered at the same time.
Besides configuring the recording schedule, you have to configure the settings on the Motion
Detection and Alarm Input Settings interfaces.
Please refer to Section 6.6.1 and Section 6.6.4 for detailed information.
10) Record Triggered by Motion | Alarm
If you select Motion | Alarm, the video will be recorded when the external alarm is triggered or
the motion is detected.
Besides configuring the recording schedule, you have to configure the settings on the Motion
Detection and Alarm Input Settings interfaces.
Please refer to Section 6.6.1 and Section 6.6.4 for detailed information.
Figure 7-‐8
Edit Record Schedule
!
Check the checkbox of Select All and click Copy to copy settings of this day to the
whole week. You can also check any of the checkboxes before the date and click
Copy.
!
Click OK to save the settings and exit the Edit Record Schedule interface.
11) Click Save to save the settings.
7.3 Configuring Snapshot Settings
Purpose:
You can configure the scheduled snapshot and event-‐triggered snapshot. The captured picture can be stored
in the SD card (if supported) or the netHDD (For detailed information about netHDD, please refer to Section
7.1 Configuring NAS Settings).
You can also upload the captured pictures to a FTP server.
Basic Settings Steps:
!
Enter the Snapshot Settings interface:
Configuration > Advanced Configuration > Storage > Snapshot
!
Check the Enable Timing Snapshot checkbox to enable continuous snapshot.