3xLogic VSX-1.3MP-PIR1 User Manual - page 57
User Manual|
VISIX Network Camera
10225 Westmoor Drive, Suite 300, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
57
Figure 6-‐41
Alarm Input Settings
3) Click Edit to set the arming schedule for the alarm input. Refer to Task 2 Set the Arming Schedule
for Motion Detectionin Section 6.6.1.
4) Check the checkbox to select the linkage method taken for the alarm input. Refer to Task 3 Set the
Alarm Actions for Motion Detectionin Section 6.6.1.
5) You can also choose the PTZ linking for the alarm input if your camera is installed with a pan/tilt
unit. Check the relative checkbox and select the No. to enable Preset Calling, Patrol Calling or
Pattern Calling.
6) You can copy your settings to other alarm inputs.
7) Click Save to save the settings.
CONFIGURING ALARM OUTPUT
Steps:
1) Enter the Alarm Output Settings interface:
Configuration>Advanced Configuration> Events > Alarm Output
2) Select one alarm output channel in the Alarm Output drop-‐down list. You can also set a name for
the alarm output (optional).
3) The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or Manual. The delay
time refers to the time duration that the alarm output remains in effect after alarm occurs.
4) Click Edit to enter the Edit Schedule Time interface. The time schedule configuration is the same as
the settings of the arming schedule for motion detection Refer to Task 2 Set the Arming Schedule
for Motion Detection in Section 6.6.1.
5) You can copy the settings to other alarm outputs.
6) Click Save to save the settings.