Baby Lock ellegante BLG guid Instruction And Reference Manual - Operation Buttons

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS

3

Operation Buttons

a “Start/Stop” button

Press this button and the machine will sew a few stitches at a 

slow speed and then begin sewing at the speed set by the 

sewing speed controller. Press the button again to stop the 

machine. Hold the button in to sew at the machine’s slowest 

speed. The button changes color according to the machine’s 

operation mode.

b “Reverse/Reinforcement Stitch” button

Use this button to sew reinforcement stitches at the beginning 

and end of sewing. Press this button, and the machine sews 3 

stitches in the same spot and stops automatically. For straight 

and zigzag stitch patterns that take reverse stitches, the 

machine will sew reverse stitches at low speed only while 

holding down the “Reverse/Reinforcement Stitch“ button (the 

stitches are sewn in the opposite direction).

c “Needle Position” button

Use this button when changing sewing direction or for detailed 

sewing in small areas. Press this button to raise or lower the 

needle position. Press the button twice to sew a single stitch.

d “Thread Cutter” button

Press this button after sewing to automatically trim the excess 

thread.

e “Presser Foot Lifter” button

Press this button to lower the presser foot and apply pressure to 

the fabric. Press this button again to raise the presser foot.

f Sewing Speed controller

Use this controller to adjust the sewing speed. Move the slide to 

the left to sew at slower speeds. Move the slide to the right to 

sew at higher speeds. Beginners should sew at a slow speed.

g “Automatic Threading” button

Use this button to automatically thread the needle.

Included Accessories

Pull the top of the flat bed attachment to open the 

accessory compartment.

a Storage space

b Presser foot storage space

c Presser foot storage space

Included Accessories 30-33 are contained in the 

embroidery unit carrying case. To open the 

embroidery unit carrying case, raise the lock and 

unlock the latch out of the position. To re-hook the 

latches and securely close the case, position the 

latch on the case and lower the lock till it snaps.

a Latches

b Locks

Green:

the machine is ready to sew or is sewing.

Red:

the machine cannot sew.

 CAUTION

• Do not press the thread cutter button after the 

threads have already been cut. Otherwise, the 

needle may break, the threads may become 

tangled, or damage to the machine may occur.

a

c

b

b

a