Bulldog Security 1402 Installation And Owner's Manual - page 10
OPERATOR PROGRAMMING INSTRUCTIONS
ENTERING PROGRAMMING MODE
Make sure your vehicle is not running and the brake is pressed. The brake is to remain pressed as long
as you want to remain in programming mode. The only exception is when a different remote has been learned.
The unit will exit the programming mode simply by releasing the brake and the parking lights will flash
three (3) times.
PROGRAMMING FOR KEYLESS ENTRY
TO PROGRAM IGNITION CONTROLLED DOOR LOCKS ON
A. Turn the ignition switch on vehicle to the on or run position.
B. Press and hold button #1 on transmitter for approximately 1 0 seconds or until parking lights
flash once. Release button #1.
C. Press and release button #2 on the transmitter. The parking lights will flash twice and the
LED will begin to flash.
D. Press button #1 on the transmitter. The parking lights will flash once indicating ignition
controlled door locks are on.
E. Turn the ignition switch to the off position. The parking lights will flash 3 times and the
LED will stop flashing. Your vehicle now has ignition controlled door locks.
TO TURN IGNITION CONTROLLED DOOR LOCKS OFF
Repeat above procedure. In step D, the parking lights will flash twice instead of once.
PARKING LIGHT FLASHES
SETTING
1
On
2
Off
TO PROGRAM PASSIVE ARMING WITH OR WITHOUT DOOR LOCKS
A. Make sure system is disarmed.
B. Turn the ignition to the on or run position.
C. Press and hold button #1 on the transmitter for approximately 10 seconds or until the parking
lights flash once.
D. Press and release button #3. The parking lights will flash 3 times and the LED will begin to
flash.
E. Press and release button #2 until the desired option is selected:
-1 Parking light flash = Door lock in passive arming
-2 Parking light flashes = Doors won't lock in passive arming
-3 Parking light flashes = Passive arming is not turned on (To turn on passive arming, refer
to passive arming on in programming options)
F. Turn the ignition switch to the off position. The parking lights will flash 3 times and the
LED will stop flashing.
TO PROGRAM IGNITION CONTROLLED DOOR LOCKS ON/OFF
If you turned this feature on in programming options for keyless entry, then it is turned on for
the alarm feature. To turn this feature on and off, please make sure the system is disarmed and
follow the procedures for ignition controlled door locks in the keyless entry, section.
OPTIONAL FUNCTIONS
OPTIONAL ACCESSORY ONE (Optional Equipment Required)
This accessory can be used for remote engine starting, remotely popping the trunk, etc. (Additional
Module Required) Press transmitter button #2. The parking lights will stay on and the installed
accessory will activate for as long as the button is pressed. NOTE. When using this option while
the system is armed, the negative input sensor will shut off for 2 minutes. If the ignition is turned
on, the negative input sensor is off for 5 seconds after the ignition is turned off. CAUTION - As
long as transmitter button #2 is pressed, a ground signal is applied to the accessory.
OPTIONAL ACCESSORY TWO (Trunk Release, Etc.) (Must Use Relay)
Press and release transmitter button #3 and the optional accessory will activate (if connected).
NOTE: When using this option while the system is armed, the negative input sensor will turn off for
2 minutes. If the ignition is turned on, the negative input sensor is off for 5 seconds after the
ignition is turned off.
PROGRAMMING OPTIONS FOR ALARM
TO PROGRAM FULL TIME SILENT ARMING ON
NOTE: When used as an alarm, make sure system is disarmed.
9