Bulldog Security 1402 Installation And Owner's Manual - page 2
SYSTEM FEATURES
SYSTEM COMPONENTS
1
2 Four-Button Extended
Control your car from an extended distance.
Range Remote Control
Keyless Entry
Remotely locks and unlocks your power door locks.
Remote Locking and
Remotely locks your power door locks when the ignition is turned on and
Unlocking with Ignition
unlocks your power door locks when the ignition is turned off. NOTE: This
Switch
feature can also be used while the unit is wired as an alarm.
Remote Valet
Lets you program off the alarm section when it is not needed.
Remote Full Time
This system will perform all its functions except no chirping when arming
Silent Arming
or disarming the system.
Remotely Programmable
Automatically arms the system one minute after the last door is closed.
Passive Arming
Delayed Dome
Set this option if your vehicle has delayed dome lights to prevent false
Light Bypass
alarms.
Last Door Closed
When the last door is closed, a series of beeps or chirps (long, short,
Indicator Programmable
long) will be heard when the unit is programmed for passive arming. NOTE:
This is disabled when the delayed dome light bypass feature is turned on.
Automatic Annoyance
If the same zone is violated three times while the system is armed, that
Override
zone will be deactivated until the unit is disarmed and rearmed.
On-Board Parking
Built-in relay provides a positive (+) parking light output. No relay needed.
Light Relay
Instant Panic Personal
Provides instant protection by sounding the car’s horn or siren (not included).
Protection
Plug In Six Function LED A visual theft deterrent that flashes when the system is armed. Lets you
Status Indicator
know which zone has been violated, and provides a visual reference for you.
E Square Memory Backup
The system will memorize its programmed features in the event that the
power is lost.
Code Learning
Allows your remote starter to learn new remotes, should you want to add
remotes, or if remotes are lost.
Optional Features
Accessory Output #1 Accessory Output #2 Horn Beep or Siren Dome Light
(Relays required)
Supervision, Starter Disable
Limited Lifetime
Guarantees life-long protection.
Warranty
Your system includes:
1-Installation & Operation Guide
1-Main Control Module
2-Four Button Remote Transmitters
1-Wire Harness
1-Momentary Switch
1-LED Status Indicator and Bracket
1-Warranty
You will need a computer-friendly test light and a 5/16 drill bit when mounting the hood pin switch.
In most cases no additional tools are required, however if the bottom of your dash on the driver’s
side will come off you must remove it. In this case a screwdriver or socket set may be needed.
REQUIRED TOOLS