Bulldog Security 1402 Installation And Owner's Manual - page 3
TECHNICAL ASSISTANCE
Should you need help. First check our website at www.bulldogsecurity.com/wires.htm or call our toll-free
Tech Support Hotline Monday through Friday 9AM-8PM and Saturday 10AM-4PM EST at 800-878-8007.
You must give the following information:
•Name
•Telephone Number with Area Code (Fax number if applicable)
•Year, Make, and Model of the vehicle
•The model number of the system you are installing
•The type of assistance you are requesting
If you give the above information you will be called back as soon as possible, usually within 10 minutes.
BEFORE YOU BEGIN
PRECAUTIONS
This system is designed for vehicles with power door locks only.
This system will add remote keyless entry features to any vehicle with power door locks. This will also
work as a replacement system for the factory installed keyless entry system.
Use masking tape to indicate the preferred mounting locations of interior components, LED and override
switch.
Disconnect the dome light fuse until you are ready to plug the unit in.
DO NOT use mechanical wiring connections, such as crimp or snap together taps. Follow instructions
on pages 2-3.
DO NOT disconnect the battery if the vehicle has an anti-theft-coded radio or is equipped with an airbag.
Doing so may cause a warning light to be displayed and may require a trip to the dealer to be corrected.
DO NOT leave the interior or exterior lights on for an extended period of time as it may cause battery
drain.
DO NOT mount the control module until all connections have been made and tested. Using wire ties or
double sided tape, MOUNT THE MODULE UNDER THE DASH.
DO NOT plug the harnesses into the control module until all connections have been made. Be careful to
line up the pins on the unit with the wiring harness plug (lip up - Red wire to the right). Failure to
do this will cause severe damage to the unit and possibly to the vehicle.
2
Congratulations, you have purchased one of the most advanced alarm systems ever made. Your new system
is a technological breakthrough utilizing the most advanced, state of the art technology and components.
It is computer controlled and manufactured in the U.S.A. The dependability and variety of features
make Bulldog Security the leader in the industry. Enjoy your new system for years to come!
Since there are many different makes and models of vehicles, look at the wiring chart on our website,
www.bulldogsecurity.com/wires.htm.
Read this manual thoroughly before starting the installation.
When testing for a positive or negative voltage, you must use a computer friendly test light (logic probe)
or a volt/ohm meter. Make sure to probe and test each wire before making your connections.
TESTING YOUR WIRES