Bulldog Security 1402 Installation And Owner's Manual - page 12
11
PROGRAMMING TABLES
TO ENTER OPERATING PROGRAMMING MODE
A. Turn the ignition switch to the on or run position.
B. Press and hold transmitter button #1 for approximately 10 seconds or until the parking lights
flash once.
C. Press one of the following buttons to go to the following tables:
BUTTON FLASHES
SETTING
2
2
TABLE #1
3
3
TABLE #2
4
4
TABLE #3
NOTE: Bold items are factory default settings. Once you enter a programming table, you must start
the procedure over to enter a different table.
TABLE ONE
BUTTON FLASHES
SETTING
1
1
Ignition Controlled Door Locks On
2
Ignition Controlled Door Locks Off
3
1
Silent Arming On (Full Time)
2
Silent Arming Off
4
Within 15 seconds of pressing button #4, press any button on your
new transmitter. If your new transmitter is programmed, the parking
lights will flash 1 time. If no new transmitter is programmed within
15 seconds, the parking lights will flash 3 times.
TABLE TWO
BUTTON FLASHES
SETTING
1
1
Passive Arming On
2
Passive Arming Off
2
1
Passive Arming With Door Locks
2
Passive Arming Without Door Locks
3
Passive Arming Is Not Activated
TABLE THREE
BUTTON FLASHES
SETTING
4
4
Erasing E-Squared Memory Restoring Factory Defaults
CAUTION: When button #4 is selected, the parking lights will flash 4 times. The unit will return to
all factory default settings and all transmitter codes will be erased. To Program lst remote: Remove
power from unit, then power up again.
TO EXIT PROGRAMMING MODE
Turn off ignition. The parking lights will flash 3 times and the LED will stop flashing. The new
settings will now be programmed into your system.
TO ENTER INSTALLATION PROGRAMMING MODE
CAUTION: Only access these features if instructed b authorized personnel or if the unit's memory
has been reset to factory defaults. Please call Technical Support at 1(800) 878-8007 for assistance.
NOTE: When using as an alarm, make sure system is disarmed.
A. Turn the ignition switch to the on or run position.
B. Press and hold transmitter button #1 for approximately 10 seconds or until the parking lights
flash once.
C. Press one of the following buttons to go to the following tables:
BUTTON FLASHES
SETTING
1
1
TABLE #4
2
2
TABLE #5
NOTE: Bold items are factory default settings.
TABLE FOUR
BUTTON FLASHES
SETTING
1
1
0.6 sec. Door Lock Pulse Length