Bulldog Security 1402 Installation And Owner's Manual - page 14
13
This feature is useful when having your vehicle valet parked, washed or serviced. While in valet mode,
keyless entry and instant panic will still work; however, the alarm will not arm. Valet mode may
also be programmed while the engine is running.
Arming Press transmitter button #1 to arm the system. The siren will chirp or the horn will sound
once. The parking lights will flash once, the power door locks will lock (if installed) and the LED
will flash slowly indicating the alarm is now armed. The engine starter is also disabled (if installed).
DISARMING
Pressing transmitter button #1 again will disarm the system. The siren will chirp or the horn will
sound twice. The parking lights will flash twice and stay illuminated for 30 seconds, and the power
door locks will unlock (if installed), acknowledging that the system is disarmed. NOTE: If you hear
3 or 4 siren chirps or horn beeps or see 3 or 4 parking light flashes when disarming, the vehicle
was violated while you were away. Check the LED for zone violation (See Operating Instructions - LED
Status Indicator). This is a good time to check your vehicle for possible damage. When disarming,
the dome light will turn on for 30 seconds (if installed).
ONE TIME SILENT ARMING/DISARMING
Should you desire not to have the siren chirp or horn beep when arming and disarming for this arming
only, press and hold transmitter button 91 for 3 seconds. The system will perform all its usual arming
functions, except there will be no arming and disarming chirps or beeps. If the alarm is triggered,
the siren or horn will provide its normally loud sound.
PASSIVE ARMING
See Alarm Programming Options for Passive Arming. NOTE: When the last door is closed, you will hear
a series of chirps (long-short-long) indicating system is now in arming countdown. The unit will be
fully armed in 30 seconds.
FULLTIME SILENT ARMING/DISARMING
See Alarm Programming Options for Full Time Silent Arming/Disarming. NOTE: When in Passive Arming,
you will not hear the last door-closed alert, 30 second warning chirp or the arming chirp.
OVERRIDE SWITCH
In the event your remote control is lost, damaged, malfunctions; this or switch allows you to disarm
your system. You must first open the door, turn the ignition key to the "ON" position, then press
and hold the override switch for 3 seconds. The siren or horn will silence and you will be able to
start the engine. A second way to use this feature is to open a door and cycle the key on and off 3
times in 1 second (No Switch Used). NOTE: A door must remain open during both procedures.
FULL TIME INSTANT PERSONAL PANIC PROTECTION
Press and release transmitter button #4 to sound the instant panic alert. The lights and horn or
siren (If Installed) will activate for 30 seconds and then shut off. To stop the alert before the
30 seconds, press any of the 4 transmitter buttons. This feature functions if the system is armed,
disarmed or in keyless entry mode, even if the engine is running.